Check category
资讯详情
How to adjust the starter
- Categories:news
- Author:
- Origin:
- Time of issue:2021-12-29
- Views:0
(Summary description)During normal use of the starter shaft, necessary adjustments should be made when there is poor meshing, impact, difficulty in starting, or after maintenance. The adjustment of the starter refers to the coordinated adjustment of the meshing of the drive gear and the time when the starter switch is turned on during the starting work.
How to adjust the starter
During normal use of the starter shaft, necessary adjustments should be made when there is poor meshing, impact, difficulty in starting, or after maintenance. The adjustment of the starter refers to the coordinated adjustment of the meshing of the drive gear and the time when the starter switch is turned on during the starting work.
How to adjust the starter
(Summary description)During normal use of the starter shaft, necessary adjustments should be made when there is poor meshing, impact, difficulty in starting, or after maintenance. The adjustment of the starter refers to the coordinated adjustment of the meshing of the drive gear and the time when the starter switch is turned on during the starting work.
- Categories:news
- Author:
- Origin:
- Time of issue:2021-12-29
- Views:0
Information
During normal use of the starter shaft, necessary adjustments should be made when there is poor meshing, impact, difficulty in starting, or after maintenance. The adjustment of the starter refers to the coordinated adjustment of the meshing of the drive gear and the time when the starter switch is turned on during the starting work.
(1) Adjustment of drive gear and thrust ring. Push the movable iron core of the electromagnetic switch to the position where the contact plate is just connected and keep it stable. Measure the air gap value between the drive gear and the end face of the thrust nut. It should be within the range of 4-5mm, otherwise, it can be screwed in or screwed appropriately. Adjust the connecting screw between the shift fork and the iron core. Then push the movable iron core to the limit position. The gap value should be reduced to 1.5-2.5mm. If it does not match, the stroke limit screw on the rear cover can be adjusted until it is qualified. However, in some foreign electromagnetic-operated starters, in addition to adjusting the connecting screw, there is also a fork-shaped joint connected to the movable iron core by rotating the shift fork, and the other is a method of adding or subtracting washers on the end surface of the solenoid switch coil. Make adjustments.
(2) Adjust the time when the start switch is turned on. When the electromagnetic switch is just turned on, the gap between the drive gear and the end face of the thrust nut should be between 3.5-5.5mm, that is, the drive gear has meshed into the flywheel ring gear, but has not yet entered a fully meshed state. If the switch on time is improper, it can be adjusted by the connecting bolt (adjusting rod) between the fork lever and the movable iron core of the electromagnetic switch
Keyword:
Scan the QR code to read on your phone
news
Quick navigation
MESSAGES
底部留言
Description:
Copyright © 2022 Zhejiang Noontimes Autoparts Co., Ltd. Powered by www.300.cn seo